XciteRC Xtide Micro RTR Operations Instructions download pdf (Page 19)

X-TIDE micro

Binding · Getting started

BINDING:

The 2.4 GHz receiver of X-TIDE MICRO must be once „connected“ with a suitable transmitter, the so-called

„binding“ procedure. This ensures that the receiver establishes a connection only with this transmitter and the

model can be operated without interference. This process can be repeated any time.

The transmitter and receiver of the X-TIDE MICRO are already bound so that you can start ﬂying immediately.

Should a rebind gets necessary (eg. after a transmitter change), proceed as follows:

• Make sure that no other 2.4 GHz network (eg. WLAN or other transmitter) sends nearby.

• The distance between transmitter – e.g. X-TIDE MICRO should be maximum one meter.

• Note: the X-Tide micro must be in the water so that the remote control system is activated!

• Switch on the transmitter. The green FREQUENCY LED ﬂashes for about 5 seconds. During these 5

seconds, turn on the boat. When the LED lits permanently green, the transmitter is now bound to the

X-Tide micro.

• If you still cannot control the boat, repeat the process.

Getting started

Before you begin please check:

• Insert the included soft rubber protection on the boot tip. Pay attention to the short pin, it must engage in

the provided hole on the underside of the hull. This is especially useful if you operate with several boats at

once, or eg. in a swimming pool in order not to damage it.

• NOTE: The X-Tide micro needs due to their small size a calm water surface. Do not drive in heavy seas!

•

WARNING: Only start with a sufﬁciently full transmitter batteries (rechargeable batteries) and fully

charged drive battery – crash hazard!

• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt

increases the weight and therefore can degrade the ﬂying qualities.

• Switch on the transmitter. The red POWER LED lits and the green FREQUENCY LED ﬂashes. Wait a

moment until the green FREQUENCY LED lits permanently, then connect the drive battery with the boat.

Release upper hull by turning the rear lock

and lift the back end.

Place the LiIo battery in the battery holder.

WARNING: Operate your boat only

with a fully charged battery – loss of con-

trol!

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

No comments

XciteRC Xtide Micro RTR Operations Instructions Page 19