XciteRC Xtide Micro RTR Operations Instructions download pdf (Page 22)

X-TIDE micro

Troubleshooting

WARNING: disconnect and remove the drive battery from the boat after each ride – ﬁre and explo-

sion hazard!

WARNING: the motor of the X-TIDE MICRO may get very hot during operation. Allow to cool down

minimum 20 minutes before the next start to avoid damage. Fire hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good

condition and to minimize wear.

• The X-Tide micro is waterproof, yet it may happen that a few drops of water gets lost into the boat. There-

fore check after every ride if water is inside in the hull and dry it with a cloth if necessary.

• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a

harder brush or a toothbrush can be used.

• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic

of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up

liquid.

• Check the tightness of all screws and tighten if necessary.

• Also check all connections, cables and power battery / rechargeable battery for damage.

•

WARNING: Damaged batteries or rechargeable batteries must not be used again and must be

disposed of immediately – ﬁre hazard! Please note the disposal notes at the end of this manual.

• Check the model for worn, broken or jammed parts and gears and repair if necessary.

•

WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in

use – ﬁre hazard!

Troubleshooting

Problem Possible Cause Corrective Action

Transmitter does

not work

No batteries inserted

Polarity of the batteries reversed

ON/OFF switch in position OFF

Place 6 x AA batteries into the transmitter

Check polarity of the inserted batteries,

and correct if necessary

Switch transmitter ON

Transmitter POW-

ER-LED ﬂashes

weak batteries, almost empty Insert new batteries

The X-Tide micro

does not react on

the transmitter

Transmitter does not work

Drive battery is almost empty

Motor defective

Boat is not in the water

Transmitter and receiver are not bound

See “Transmitter does not work”

Recharge battery according to the inst-

ructions

Check and replace the motor

Safety function activated, place boat in

the water

Bind transmitter and receiver, see „BIN-

DING“

The X-Tide micro

gets out of control

or stops suddenly

Transmitter signal shielded

Boat outside the maximum range

Propeller defective

Change location, without any obstruc-

tions between the transmitter and boat

Observe the maximum range (100 m)

Check, replace if necessary

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comments to this Manuals

No comments

XciteRC Xtide Micro RTR Operations Instructions Page 22

Comments to this Manuals

Related products and manuals for Remote controlled toys XciteRC Xtide Micro RTR